Thingiverse
Dragon Flight 95 Hatch
by bgsteveg
23
Downloads
22
Likes
0
Makes
Printed hatch for the Dragon Flight 95 RC yacht
Just drop into the hatch opening and seal with hatch tape.
A lot easier than patches
Fitted with a loop, so you can tie it to servo tray on the boat so as you won't forget or loose them.
Put the loop on the starboard side to keep it clear of the winch lines.
For my DF65 hatches see, https://www.thingiverse.com/thing:1666297
Printed at 0.1mm layer height as it's only 0.5mm thick and this gives at least 3 layers.
This helps make sure
Just drop into the hatch opening and seal with hatch tape.
A lot easier than patches
Fitted with a loop, so you can tie it to servo tray on the boat so as you won't forget or loose them.
Put the loop on the starboard side to keep it clear of the winch lines.
For my DF65 hatches see, https://www.thingiverse.com/thing:1666297
Printed at 0.1mm layer height as it's only 0.5mm thick and this gives at least 3 layers.
This helps make sure
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in