Thingiverse
Wire Harness Boot for Rear Hatch Group Vag FIX
by Gc9n
11
Downloads
15
Likes
1
Makes
Did you Manage to Break the little "tooth" from your rear wire harness tube boot because you added a rear camera or whatever????
No problem , these are 2 parts for the top and bottom plug , just print them upside down to prevent supports
You need to Glue the Part in order to work , The glue have to be compatible for All plastics, even polyethylene and polypropylene because cars material is Nylon and ours have to be PEt-G.
Dont forget to sand both parts
https://www.ebay.com/itm/Q-Bond-
No problem , these are 2 parts for the top and bottom plug , just print them upside down to prevent supports
You need to Glue the Part in order to work , The glue have to be compatible for All plastics, even polyethylene and polypropylene because cars material is Nylon and ours have to be PEt-G.
Dont forget to sand both parts
https://www.ebay.com/itm/Q-Bond-
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in