Thingiverse
Sennheiser HD650 boom microphone clamp
by harari
11
Downloads
16
Likes
0
Makes
These files are for the clamp in my HD650 microphone project. The two sides are connected with screws for plastic (no room for knurled nuts, the screws dig into the plastic)
The boom arm (flexible shaft from a USB LED light) is held with a M3 set screw and it is 5mm in diameter.
The microphone I used in a SONY ECM-DS30P stereo condenser mic.
I put a piece of cork sheet sticker on one side of the clamp to provide more friction.
I used Sugru for the strain relief.
This will also fit HD600,
The boom arm (flexible shaft from a USB LED light) is held with a M3 set screw and it is 5mm in diameter.
The microphone I used in a SONY ECM-DS30P stereo condenser mic.
I put a piece of cork sheet sticker on one side of the clamp to provide more friction.
I used Sugru for the strain relief.
This will also fit HD600,
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in