Thingiverse
Bolutek rs232 to Bluetooth BLK-MD-BC04-B
by robocog
2
Downloads
2
Likes
0
Makes
Bolutek BLK-MD-BC04-B - RS232 to Bluetooth case
Printed on my Ender 3 - using Cura
Material PLA
0.15mm layer height
No supports
No extra bed adhesion
Took just under 2 hours and came out great
It's a good fit for my unit (I placed a little strip of double sided tape to hold board to bottom tray)
Used 4 very small screws (stolen from my Trex 250 helicopter 'spares' box) to hold lid to base tray
Have set it up as 3 files -
Lid and base (Bolutek_rs232_to_Bluetooth.stl )
Just the
Printed on my Ender 3 - using Cura
Material PLA
0.15mm layer height
No supports
No extra bed adhesion
Took just under 2 hours and came out great
It's a good fit for my unit (I placed a little strip of double sided tape to hold board to bottom tray)
Used 4 very small screws (stolen from my Trex 250 helicopter 'spares' box) to hold lid to base tray
Have set it up as 3 files -
Lid and base (Bolutek_rs232_to_Bluetooth.stl )
Just the
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in