Thingiverse
Anycubic I3 Mega Spool Holder
by dede67
50
Downloads
36
Likes
2
Makes
A filament spool holder where the spool is placed at the top edge of the printer.
The filament is turned 180° so that it can be fed from below into the extruder (which is at its standard installation location).
Only the metal ball has to be unscrewed from the filament sensor, with which it is otherwise attached to the magnet.
When changing filaments, it is first fed (through the sensor) directly into the extruder and then threaded into the *deflection device* in the second step.
BOM:
3x 6
The filament is turned 180° so that it can be fed from below into the extruder (which is at its standard installation location).
Only the metal ball has to be unscrewed from the filament sensor, with which it is otherwise attached to the magnet.
When changing filaments, it is first fed (through the sensor) directly into the extruder and then threaded into the *deflection device* in the second step.
BOM:
3x 6
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in