Thingiverse
Filament Dryer Thermostat using DS18B20 Temperature sensor
by shivackt
84
Downloads
83
Likes
0
Makes
First Special thanks to MirageC a wonderful design.
I Remixed the design of MirageC for my requirement
This project is very helpful for pre-heating our 3D printer filaments.
The main aim to remove the moisture level of the filaments which helps a lot in improving 3D printing.
The hear of the circuit is Arduino where the code is written in Arduino and we used DS18B20 temp sensor and a relay to switch On/OFF the heater.
The code is written for predefined values like temperature for dif
I Remixed the design of MirageC for my requirement
This project is very helpful for pre-heating our 3D printer filaments.
The main aim to remove the moisture level of the filaments which helps a lot in improving 3D printing.
The hear of the circuit is Arduino where the code is written in Arduino and we used DS18B20 temp sensor and a relay to switch On/OFF the heater.
The code is written for predefined values like temperature for dif
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in