Thingiverse
Nema23 end cap housing
by cmwwebfx
16
Downloads
13
Likes
0
Makes
I am a bit of a perfectionist when it comes to machine building and electrical. I have designed this end cap to house the openbuilds Xtension connector as I prefer to rewire all my steppers with shielded cable.
To assemble this, there is an end cap, and plug clamp to ensure the Xtension connector does not move out of position. The end cap has two cutouts so that you can tighten down the shielded cable using 1.5mm cable ties.
The openbuilds connectors can be [found here](https://openbuild
To assemble this, there is an end cap, and plug clamp to ensure the Xtension connector does not move out of position. The end cap has two cutouts so that you can tighten down the shielded cable using 1.5mm cable ties.
The openbuilds connectors can be [found here](https://openbuild
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in