Thingiverse
Pokeball Plus Joystick Extender
by dude2k5
7
Downloads
11
Likes
0
Makes
Decided the joystick on the pokeball plus was too small for my thumb.
So I found a similar joystick extender and modified it to fit the pokeball plus, and made the button much larger. The outside edge is even a little thinner, which allows the light from the LED to show a bit better.
If you have any suggestions, im open to them!
Hope you guys like it
I printed at .1mm-.2mm, 20%-50% infill WITH supports
Should take less than 30 minutes!
Small GIF of the light around the ring
So I found a similar joystick extender and modified it to fit the pokeball plus, and made the button much larger. The outside edge is even a little thinner, which allows the light from the LED to show a bit better.
If you have any suggestions, im open to them!
Hope you guys like it
I printed at .1mm-.2mm, 20%-50% infill WITH supports
Should take less than 30 minutes!
Small GIF of the light around the ring
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in