Thingiverse
HICTOP 3DP-11 Bodwen X-Carriage with BT Touch
by n7jti
7
Downloads
7
Likes
0
Makes
## HICTOP 3DP-11 X-Carriage for Boden Tube E3D V6 hot-end with a BT Touch
This is a design for an X-Carriage for my HICTOP 3DP 11 that incorporates a holder for the BT Touch. I also modeled a holder for my blower motor that replaces the normal end-clamp.
This is finally done, and installed in my printer. Here are the settings I got for my setup. Your's may vary.
Y-Offset: 0 (by design, the BT Touch is exactly even with the extruder port)
X-Offset: +25
Z-Offset: -1.4
In this thi
This is a design for an X-Carriage for my HICTOP 3DP 11 that incorporates a holder for the BT Touch. I also modeled a holder for my blower motor that replaces the normal end-clamp.
This is finally done, and installed in my printer. Here are the settings I got for my setup. Your's may vary.
Y-Offset: 0 (by design, the BT Touch is exactly even with the extruder port)
X-Offset: +25
Z-Offset: -1.4
In this thi
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in