Jansjö Lamp Mount 2020

This mount is supposed to let you mount your Jansjö Ikea lamp to yout 2020 3D printer.

You need two M4 screws and two T4 nuts

Build instructions:
- remove the cable holder in the Jansjö clamp and cut the cable between the light switch and the actual lamp
- screw the lamp out of the clamp (it sits very tight, so you need to use some force)
- pass the cable through the hole and screw the lamp into the middle hole of the mount
- reconnect the cut-through cable
- use two M4 screws and T4