Thingiverse
Speaker Grid with Name
by drgrandios
40
Downloads
44
Likes
0
Makes
A speaker grid for the boom boxes of my two daughters (see https://www.thingiverse.com/thing:3318852 for the build).
The default diameter of the M3 holes is set to 96mm - the grid itself should cover an 8 cm speaker without problems.
Use the m3test.stl to check if the generated M3 mount comes out correctly on your printer.
Note: OpenSCAD needs about 10 minutes to render the model (at least on my laptop)
Use the following values for a Visaton FRS-8 M (mounting holes are aligned w
The default diameter of the M3 holes is set to 96mm - the grid itself should cover an 8 cm speaker without problems.
Use the m3test.stl to check if the generated M3 mount comes out correctly on your printer.
Note: OpenSCAD needs about 10 minutes to render the model (at least on my laptop)
Use the following values for a Visaton FRS-8 M (mounting holes are aligned w
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in