Thingiverse
Mavic 2 Extension Legs
by mjhall29
38
Downloads
16
Likes
1
Makes
A set of extension Legs for the DJI Mavic 2.
They will give circa 52mm extra height. keep mavic out of the wet grass.
The rear legs have holes for forward facing lights (as in pictures).
Rear legs need to be clipped over the far end of the arm closest to the motor then slid into place as in photos.
it is important that the rear legs are fitted as shown as the clip is shaped.
20-12-18
I Have added some better photos.
Also added a modified front leg that can be printed with flexible filam
They will give circa 52mm extra height. keep mavic out of the wet grass.
The rear legs have holes for forward facing lights (as in pictures).
Rear legs need to be clipped over the far end of the arm closest to the motor then slid into place as in photos.
it is important that the rear legs are fitted as shown as the clip is shaped.
20-12-18
I Have added some better photos.
Also added a modified front leg that can be printed with flexible filam
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in