Thingiverse
Pause At Height or Layer (Dremel D3 3D45 3D40 3D20)
by javajuice
51
Downloads
38
Likes
0
Makes
This is my script for pausing at a Layer number or at Height for Dremel DigiLab 3D Slicer or Cura 2 / 3 on a Dremel 3D Printer.
Just put in the layer number where the pause should occur; for example, the layer where the color changes or the layer that prints the roof over the nut that will be inserted into the print.
G5 is used for pause. After pause you can have the extruder wipe filament using the Extrude Start / Stop Print settings.
This script is based on the following scripts:
-
Just put in the layer number where the pause should occur; for example, the layer where the color changes or the layer that prints the roof over the nut that will be inserted into the print.
G5 is used for pause. After pause you can have the extruder wipe filament using the Extrude Start / Stop Print settings.
This script is based on the following scripts:
-
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in