Thingiverse
WS2811 strip holder clip
by motarr
3
Downloads
6
Likes
0
Makes
No special settings needed.
However you should rotate the model so it's upright so you can print it without infill and support.
I also advice to do at least one test print to check if your printer has the same tolerances regarding the strip width/height as mine did,
However you should rotate the model so it's upright so you can print it without infill and support.
I also advice to do at least one test print to check if your printer has the same tolerances regarding the strip width/height as mine did,
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in