Thingiverse
AirHockey striker and puck
by Mizcak
11
Downloads
14
Likes
0
Makes
Replacement airhockey striker and puck.
Dimensions
Striker: 69 mm diameter, 50 mm height.
Puck: 35 mm diameter, 3 mm height.
Printed well in ABS with 0.2 mm layers and 0.4mm nozzle without raft or brim. The puck does print without support if your printer is somewhat good at bridging, it will however not be the most pleasant to look at if viewed from underneath.
It's recommended to slide the puck over some sandpaper on both sides to get a uniform flat surface. Also attach some fabric
Dimensions
Striker: 69 mm diameter, 50 mm height.
Puck: 35 mm diameter, 3 mm height.
Printed well in ABS with 0.2 mm layers and 0.4mm nozzle without raft or brim. The puck does print without support if your printer is somewhat good at bridging, it will however not be the most pleasant to look at if viewed from underneath.
It's recommended to slide the puck over some sandpaper on both sides to get a uniform flat surface. Also attach some fabric
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in