Thingiverse
Keenovo CR-10S Box
by Bjax
6
Downloads
6
Likes
0
Makes
Needed a box to Keenovo LCD display for my CR-10S 5. The cables too short to put it on the frame at the top.
Made a holder for my CR-10S box.
Lock display in box with 2 sprint.
Printed with PETG 15%, no support but PLA is just as good.
Avoid ABS as it shrinks. If not, scale it up a little bit. (maybe 101%?)
The holes on the right lower side are if you want to drill and fasten it even better.
Do not know if the original filament bracket fits because I do not use it and have thrown it
Made a holder for my CR-10S box.
Lock display in box with 2 sprint.
Printed with PETG 15%, no support but PLA is just as good.
Avoid ABS as it shrinks. If not, scale it up a little bit. (maybe 101%?)
The holes on the right lower side are if you want to drill and fasten it even better.
Do not know if the original filament bracket fits because I do not use it and have thrown it
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in