Thingiverse
Spinning Zoetrope
by ggiavelli
13
Downloads
4
Likes
0
Makes
Update: Added the stand.
This is A Production Stage (aka it works and prints)
Print the handle vertically with prongs on top.With a BRIM. No support
Print the base no supports no brim. this is important.
You slowly fold out each piece after its printed so that it all forms a flat plane. the pieces will tend to lock so go slow and do not over force as you move them outwards.
The handle takes about 30 mins to print and the base a good 6 hours. Phew!
Push prongs of handle into ba
This is A Production Stage (aka it works and prints)
Print the handle vertically with prongs on top.With a BRIM. No support
Print the base no supports no brim. this is important.
You slowly fold out each piece after its printed so that it all forms a flat plane. the pieces will tend to lock so go slow and do not over force as you move them outwards.
The handle takes about 30 mins to print and the base a good 6 hours. Phew!
Push prongs of handle into ba
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in