Thingiverse
Geeetech A10M Bed Clip v2
by fishku
220
Downloads
129
Likes
2
Makes
This is a bed clip to replace the metal clips that come with some Geeetech printers.
The problem is that the metal clips can cause a short circuit on the underside of the heated bed when they scratch away the paint.
By using these bed clips, you eliminate the problem of short circuits.
This is a newer version than my previous bed clip. The issue I had was that the clip would not offer enough grip after a few prints. The reason was that the "springy" part would get too close to the heat be
The problem is that the metal clips can cause a short circuit on the underside of the heated bed when they scratch away the paint.
By using these bed clips, you eliminate the problem of short circuits.
This is a newer version than my previous bed clip. The issue I had was that the clip would not offer enough grip after a few prints. The reason was that the "springy" part would get too close to the heat be
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in