Thingiverse
Roomba Charger Command Strip Bracket
by dantu
101
Downloads
55
Likes
0
Makes
Roomba Charger Command Strip Bracket
This bracket fits on a Roomba charger and is just large enough for 2-3 medium sized 3M command strips to hold it against the wall or baseboard.
It's probably a little thicker than it needs to be, but my previous print broke, so I wasn't taking any chances. This one has held up for 3 months no with no obvious signs of wear.
This is small enough to fit on a 12x12 print bed, if you rotate it 45 degrees and keep the skirt or brim to about 1mm. Note that
This bracket fits on a Roomba charger and is just large enough for 2-3 medium sized 3M command strips to hold it against the wall or baseboard.
It's probably a little thicker than it needs to be, but my previous print broke, so I wasn't taking any chances. This one has held up for 3 months no with no obvious signs of wear.
This is small enough to fit on a 12x12 print bed, if you rotate it 45 degrees and keep the skirt or brim to about 1mm. Note that
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in