Thingiverse
Filament Guide and Mount for Sunhokey filament sensor
by wwendorf
30
Downloads
15
Likes
0
Makes
This is a mount I designed for use with my Railcore II 300-ZL and the sunhokey filament out sensor.
The 3rd pic shows where the sensor gets plugged in, and the order of the wires in the plug you have to attach is White - Red - Black from left to right.
Update 4/27/20:
If using Duet2 add:
M591 D0 P1 C3 S1 ; enabled filament out sensor
to the end of your config.g to enable the sensor. You will also most likely have to re-pin the connector. Just new a small (as in tiny) flat
The 3rd pic shows where the sensor gets plugged in, and the order of the wires in the plug you have to attach is White - Red - Black from left to right.
Update 4/27/20:
If using Duet2 add:
M591 D0 P1 C3 S1 ; enabled filament out sensor
to the end of your config.g to enable the sensor. You will also most likely have to re-pin the connector. Just new a small (as in tiny) flat
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in