Thingiverse
Electronic's Enclosure
by Printlapse
55
Downloads
31
Likes
0
Makes
Was designed as an enclosure for my relay board I was using for my create of the DIY Mr. Bullet Feeder on my LEE Reloading set up.
Instructions:
Attach the box to the respected area. The screw holes inside the enclosure are 1.5mm in size so use what screws you have that fit. After assembled, attach the lid and those screw holes are also 1.5mm in size. I used #6 1/2" sheet metal screws because that's what I had at the time. Works fine.
This is used in my OpenbulletFeeder- DIY Bullet Feeder
Instructions:
Attach the box to the respected area. The screw holes inside the enclosure are 1.5mm in size so use what screws you have that fit. After assembled, attach the lid and those screw holes are also 1.5mm in size. I used #6 1/2" sheet metal screws because that's what I had at the time. Works fine.
This is used in my OpenbulletFeeder- DIY Bullet Feeder
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in