Thingiverse
Simple Watch Winder
by swolebro
2
Downloads
4
Likes
0
Makes
This is a part to cobble together a simple watch winder.
It's just a base that you hook onto a stepper or servo motor, then control however you like. Either use the one with a pre-built 0.25" bore or print the pilot bore one with 100% infill and drill it for the desired shaft diameter. A series of holes along the spine let you zip-tie your watch in place. (Mine has a 6mo rechargeable battery, so I that hacky method works fine enough for me.)
You may need to ream open the holes a bit for bi
It's just a base that you hook onto a stepper or servo motor, then control however you like. Either use the one with a pre-built 0.25" bore or print the pilot bore one with 100% infill and drill it for the desired shaft diameter. A series of holes along the spine let you zip-tie your watch in place. (Mine has a 6mo rechargeable battery, so I that hacky method works fine enough for me.)
You may need to ream open the holes a bit for bi
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in