Thingiverse
Original Prusa i3 MK3 Einsy + Raspberry Pi A+ mod
by crzcrz
30
Downloads
16
Likes
0
Makes
**Update 18.09.19. I no longer own the Prusa printer so my ability to support this mod is limited.**
**Update 15.05.19. You may need to raise the soft throttling limit to 70º on A+ if you observe throttling events. Other than that there have been no issues with the mod since December last year.**
**N.B! Before you attempt this mod please be advised that you'll have to unsolder the 40-pin header from RPi A+ which has proven to be extremely difficult.**
**At the moment of writing this mod
**Update 15.05.19. You may need to raise the soft throttling limit to 70º on A+ if you observe throttling events. Other than that there have been no issues with the mod since December last year.**
**N.B! Before you attempt this mod please be advised that you'll have to unsolder the 40-pin header from RPi A+ which has proven to be extremely difficult.**
**At the moment of writing this mod
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in