Thingiverse

100mm Calibration Stick

by Tiziano149

7 Downloads

5 Likes

0 Makes

Download Model

100mm calibrate calibration extruder extrusion Flow flowrate mmstep mmsteps multiplier precision rate steps stepsmm stick 100mm calibrate calibration extruder extrusion Flow flowrate mmstep mmsteps multiplier precision rate steps stepsmm stick

Use this 100mm stick to precisely calibrate your extruder steps without wasting a lot of filament.

1. Hold the stick where the filament enters the extruder.

2. Stick a piece of tape at the end of the stick (don't use a pen), so that it is exactly 100mm from the filament inlet.

3. Send G92 E0 to zero the extruder counter.

4. From your control panel, extrude as much filament so that the tape reaches the inlet.

5. Send M114 and read how much your extruder (E) "thinks" it extruded. (l

Source

Thingiverse

Comments

Makes