Thingiverse
Tronxy X5S Carriage Upgrade
by towe
93
Downloads
61
Likes
0
Makes
A carriage upgrade kit for the X5S.
I was annoyed by the four-wheeled design of the original carriage, since its fourth wheel and 40.5mm hole distance made tightening it properly a nightmare.
Since I'm using printed sleeves on 608 bearings (https://www.thingiverse.com/thing:3188237), the belts were also not straight towards the print head, front idlers, and motors.
This kit intends to fix all that.
Parts you need:
1x "y_carriage_right.stl"
1x "y_carriage_left.stl"
1x "frontidler_r.stl"
I was annoyed by the four-wheeled design of the original carriage, since its fourth wheel and 40.5mm hole distance made tightening it properly a nightmare.
Since I'm using printed sleeves on 608 bearings (https://www.thingiverse.com/thing:3188237), the belts were also not straight towards the print head, front idlers, and motors.
This kit intends to fix all that.
Parts you need:
1x "y_carriage_right.stl"
1x "y_carriage_left.stl"
1x "frontidler_r.stl"
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in