Case for FrSky RX6R receiver

This is a minimalist case for the FrSky RX6R. Two versions are provided, one with access to the S-Port socket (as shown), and one without.

The case fits receivers which have the servo pins and bind button on the same side of the board (this is the most common arrangement).

Putting it together:

1. Remove card wrapper from receiver, cut a piece 21 x 18 mm - this will be the new bed
2. Print the case
3. Lay the bed (from step 1) in the base
4. Place the rx board over the bed
5. Secur