Thingiverse
2020 RepRap Full Graphic Smart Controller LCD holder with usb
by sercanigk
33
Downloads
17
Likes
1
Makes
You just need:
2x M5x7.5 screws
2x M5 T-nuts
4x M3x20 screws (minimum)
4x M3 nuts
No support needed if you turn it on the front! The holes for the screws have a 0.2mm briging layer; which you have to poke a hole through after printing!
One Version is for those of you, who have an usb extension, which can be mounted in!
2x M5x7.5 screws
2x M5 T-nuts
4x M3x20 screws (minimum)
4x M3 nuts
No support needed if you turn it on the front! The holes for the screws have a 0.2mm briging layer; which you have to poke a hole through after printing!
One Version is for those of you, who have an usb extension, which can be mounted in!
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in