Thingiverse
Christmas Tree Light Project
by homewater
6
Downloads
5
Likes
0
Makes
Little Christmas Tree LED Project that uses WS2812 style LED lights connected to an Arduino Pro Micro or Mini, or any you like.
Printed in clear PLA, 40m/s and uses A LOT of hot glue!!!
Rough Instructions:
1. Print Christmas Tree Front
2. While printing take 17 LED lights of your choice, split them if required and then solder back together using short lengths of wire (2cm or less). Fiddly work, I used very bendy cheap wire which makes installation easier. Finally solder a longer wire o
Printed in clear PLA, 40m/s and uses A LOT of hot glue!!!
Rough Instructions:
1. Print Christmas Tree Front
2. While printing take 17 LED lights of your choice, split them if required and then solder back together using short lengths of wire (2cm or less). Fiddly work, I used very bendy cheap wire which makes installation easier. Finally solder a longer wire o
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in