Thingiverse
S800 FPV Wing Receiver RX Antenna Mount
by osliang
38
Downloads
23
Likes
0
Makes
This mount allows you to mount the RX antennas using the same technique that is commonly used on mini quad: zip-tie and heatshrink tube!
One antenna should be pointing upward, while the other antenna lies on the foam covered by tape, forming a right angle for optimal signal.
This is great for diversity receivers with two monopole antennas, such as the D4R-II, X4R, R-XSR etc.
3D printing settings:
Infill: 100%
No support required
My S800 build log: https://oscarliang.com/reptile-s80
One antenna should be pointing upward, while the other antenna lies on the foam covered by tape, forming a right angle for optimal signal.
This is great for diversity receivers with two monopole antennas, such as the D4R-II, X4R, R-XSR etc.
3D printing settings:
Infill: 100%
No support required
My S800 build log: https://oscarliang.com/reptile-s80
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in