Thingiverse
Creality CR 10S / 10 reinforcement brackets "without screws" Z axis
by Xeltato
34
Downloads
27
Likes
0
Makes
Support without using screws to install reinforcing bars on the Z axis.
The X axis reaches its maximum height without touching the reinforcing bars.
If you have any doubt about your installation do not hesitate to ask.
Materials:
2 rods 8 M
8 nuts 8mm
8 washers 8mm
note:
To apply the supports on the left side, it is necessary to apply a little force.
I hope you find it useful.
The X axis reaches its maximum height without touching the reinforcing bars.
If you have any doubt about your installation do not hesitate to ask.
Materials:
2 rods 8 M
8 nuts 8mm
8 washers 8mm
note:
To apply the supports on the left side, it is necessary to apply a little force.
I hope you find it useful.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in