Thingiverse
Table Saw Crown Guard with 63mm dust extraction
by Makhaira
88
Downloads
59
Likes
0
Makes
Crown guard designed for my Startrite 175 table saw (10" blade).
It may work for other saws but I expect you will need to either make a custom riving knife or adjust the design to ensure the two horizontal rods align with any riving knife cutouts.
The full STL is included, however I have also split the design for the following reasons:
- The front section is connected to the main body by a dovetail purely because of the size of my printer bed.
- To allow higher infill around the clamp
It may work for other saws but I expect you will need to either make a custom riving knife or adjust the design to ensure the two horizontal rods align with any riving knife cutouts.
The full STL is included, however I have also split the design for the following reasons:
- The front section is connected to the main body by a dovetail purely because of the size of my printer bed.
- To allow higher infill around the clamp
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in