Thingiverse

Bed Leveling Knob (for AdimLab/Prusa/CR10S & clones)

by Skyyzzamm

13 Downloads

11 Likes

1 Makes

Download Model

This replaces the tiny knobs on the Adimlab (clone of Prusa, CR-10s, etc). Use a strong PLA or ABS (I used carbon fiber PLA, very strong and easier to print). Use 100% infill. I went to the hardware store and bought four 5mm x 10mm set screws (these are hollow screws with threads on the outside and inside, using a hex wrench to screw them in place) along with four matching screws that fit my print bed, about 40mm long. Drill a hole in the center with a diameter slightly smaller than the set scre

Source

Thingiverse

Comments

Makes