Thingiverse
TBS Immortal T Holder
by Pixelcomet
17
Downloads
15
Likes
0
Makes
Holder for a TBS Immortal-T antenna for vertical alignment.
Rectangular profile prevents bending to the sides, but wants to give flexibility in up and down direction. Thus the props won't hack it into pieces, when crashing and tumbling.
It's attached with a 3mm screw into a rear bracket of the Armattan Chamelion or sililar systems.
Printing from TPU is mandatory. infill 100%, no support (for the holes) necessary.
(Hint: The design is made for normal TPU. It's NOT suitable for printing from
Rectangular profile prevents bending to the sides, but wants to give flexibility in up and down direction. Thus the props won't hack it into pieces, when crashing and tumbling.
It's attached with a 3mm screw into a rear bracket of the Armattan Chamelion or sililar systems.
Printing from TPU is mandatory. infill 100%, no support (for the holes) necessary.
(Hint: The design is made for normal TPU. It's NOT suitable for printing from
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in