Thingiverse
Extruder PTFE Clamp + LED
5
Downloads
6
Likes
0
Makes
Goodbye PC4-M6 Coupling!!
No extra bolts needed.
There are little teeth lining the inside of the clamp for extra hold. That tube ain’t going anywhere!
Shove the tube into the hole (use needle file, careful not to file away teeth), trim/shape as required.
Install optional 3mm led, bend legs.
The LED legs will just protrude out the top, so you can either use a coin battery 2035 or dupont connection.
You could use a dupont connector as a cover if not using the LED and you don’t like the leg
No extra bolts needed.
There are little teeth lining the inside of the clamp for extra hold. That tube ain’t going anywhere!
Shove the tube into the hole (use needle file, careful not to file away teeth), trim/shape as required.
Install optional 3mm led, bend legs.
The LED legs will just protrude out the top, so you can either use a coin battery 2035 or dupont connection.
You could use a dupont connector as a cover if not using the LED and you don’t like the leg
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in