Thingiverse
CR-10 hanging fan/part cooler compact edition for stock and Microswiss hotends
by junaling
136
Downloads
96
Likes
3
Makes
2019-Dec-28 : Version 2 available here : https://www.thingiverse.com/thing:4072564
Compact edition about 40% smaller using 30mm fan on the hotend of : https://www.thingiverse.com/thing:2473423
Use 40mm or 30mm fan for the blower which is capable of at least 5 CFM
Easily remove blower when printing ABS or PETG for example.
Due to the proximity of the blower tip to the heater block, printing the blower with ABS is highly recommended, PLA might just easily deform especially when enclose
Compact edition about 40% smaller using 30mm fan on the hotend of : https://www.thingiverse.com/thing:2473423
Use 40mm or 30mm fan for the blower which is capable of at least 5 CFM
Easily remove blower when printing ABS or PETG for example.
Due to the proximity of the blower tip to the heater block, printing the blower with ABS is highly recommended, PLA might just easily deform especially when enclose
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in