Blow Dart Gun

This is a Blow Dart sized for 1/2" PVC along with the mouth piece. The mouth piece I printed at 102% in ABS at 30% infill with 3 outer layers. I soaked it in boiling water for 3 minutes and it slid right on the PVC. Once cooled it was stuck on.

The dart I printed on a Tevo Tornado using Simplify3D in vase mode with 16 top layers at a layer height of .3mm which made a nice solid place to slide a 4d 1-1/2" Bright Finish nail through. I slightly headed the end of the nail to sink it in t