Thingiverse
Mini Hovercraft
by TomusC
40
Downloads
27
Likes
0
Makes
I got some mini quadrocopter stuff over, so I made this hovercraft in a size for my Ender 3 printer.
The parts I used was Kiss 24A ESC's and BrotherHobby Returner R4 2206 2300KV motors, connected to an PDB mainly to get 5v for an Eachine AIO Camera/VTX and Frsky FrSky X4RSB receiver. But this was just what I had atm.
Note: The plastic pegs on the rudders that holds the rudder bars are a little bit weak, I've replaced most of them with screws or a little bit of wire that I heated and melted
The parts I used was Kiss 24A ESC's and BrotherHobby Returner R4 2206 2300KV motors, connected to an PDB mainly to get 5v for an Eachine AIO Camera/VTX and Frsky FrSky X4RSB receiver. But this was just what I had atm.
Note: The plastic pegs on the rudders that holds the rudder bars are a little bit weak, I've replaced most of them with screws or a little bit of wire that I heated and melted
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in