Thingiverse
INON Z240 Knob Extension
by chopcat
12
Downloads
10
Likes
0
Makes
A knob extension for the Inon Z240 underwater strobe to make fiddling with gloves on a teeny bit easier.
took ages to get it to fit and I suspect you might find different tolerances depending upon which printer you use.
It seems that the different filaments give different build dimensions. All from RS the black was snug and the yellow loose. So I put some blutac in and we shall see if they end up at the bottom of the sea!
These printed with Robo R2 on high quality R2 profile.
took ages to get it to fit and I suspect you might find different tolerances depending upon which printer you use.
It seems that the different filaments give different build dimensions. All from RS the black was snug and the yellow loose. So I put some blutac in and we shall see if they end up at the bottom of the sea!
These printed with Robo R2 on high quality R2 profile.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in