Thingiverse
Life Racing ECU Mount for F88R.L-F88RS.L-F88RX.L-F88GDI
by Nisimoto
3
Downloads
2
Likes
0
Makes
This is a basic Life Racing ECU mount for F88R.L-F88RS.L-F88RX.L-F88GDI ECUs.
ECU measurements are 182.3mm wide, 105.35mm deep and 36mm tall, to spec from the manufacturer.
Bottom plate measures 215x137mm. It has printed hexagons for M4 nuts. To insert them firmly, screw in the nuts with a bolt from the other side.
You may need to separate them into two prints in your slicer
The tall bracket needs to have support enabled, and you may need to cut a small part of the bottom in the slic
ECU measurements are 182.3mm wide, 105.35mm deep and 36mm tall, to spec from the manufacturer.
Bottom plate measures 215x137mm. It has printed hexagons for M4 nuts. To insert them firmly, screw in the nuts with a bolt from the other side.
You may need to separate them into two prints in your slicer
The tall bracket needs to have support enabled, and you may need to cut a small part of the bottom in the slic
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in