Thingiverse
Tamiya LiPo Case
by Quadropus
103
Downloads
89
Likes
0
Makes
I designed this case to recycle my old LiPos and make them fit in my Tamiya truck.
One version is without clips so the top needs to be glued in place. The other one has clips to hold the lid in place but needs a well tuned and precise printer.
The case is 122mm deep and the opening is 20mm x 42mm with a 10mm radius for the corners. The battery should be a little shorter than 122mm since the cables need to be places inside the case as well.
https://www.youtube.com/watch?v=S8NUQv69abw&featu
One version is without clips so the top needs to be glued in place. The other one has clips to hold the lid in place but needs a well tuned and precise printer.
The case is 122mm deep and the opening is 20mm x 42mm with a 10mm radius for the corners. The battery should be a little shorter than 122mm since the cables need to be places inside the case as well.
https://www.youtube.com/watch?v=S8NUQv69abw&featu
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in