Thingiverse
Headphone / Headset Holder for IKEA LINNMON
by KiaArmani
2
Downloads
3
Likes
1
Makes
A headset / headphone holder for any desk made using a LINNMON table plate from IKEA.
My very first 3D model, will upload more efficient versions over time. Probably adding a version with drilling holes soon too.
Current version took me around *30 minutes* to print.
Warning: This may or may not damage the painting on your table.
--
Changelog:
V2:
* Reduced width by 75%
* Added a 5mm stopper at the end of the holding part.
* Slightly reduced height to get a better grip.
My very first 3D model, will upload more efficient versions over time. Probably adding a version with drilling holes soon too.
Current version took me around *30 minutes* to print.
Warning: This may or may not damage the painting on your table.
--
Changelog:
V2:
* Reduced width by 75%
* Added a 5mm stopper at the end of the holding part.
* Slightly reduced height to get a better grip.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in