TF PotP Cranium Controller Blank Figure

Designed in Tinkercad and printed on Creality Ender3 and CR-10.

PLA, 0.16 layer height, 1.6 wall thickness, 0.48mm top/bottom thickness, 5% infill, Lines support 73° 15% 0.04 support z-distance, no build adhesion. Sliced in cura to about a 30 minute print, all at once.

https://www.tinkercad.com/things/9cRoQVqh1B5

They are assembled at the waist and knees with a thin wire or paperclip. I left a groove to bend a bit extra up around, to keep it locked and out of the way.