Thingiverse
Frsky R9MM and T antenna Martian II bay
by Pango3001
45
Downloads
41
Likes
0
Makes
Bay is 8mm and the top plate is 1mm tall. 9mm together (duh).
Fits r9mm and the T antenna for the Frsky R9M.
Use a small piece of 3m foam tape to keep the receiver in place. Also make sure that there are no sharp bends in your antenna wire to keep signal integrity. I have gotten some impressive distances with this setup.
Print at whatever settings you want. I printed at .2mm with 20% infill.
My designs are powered by beer, time, and filament. If you like my design and feel gener
Fits r9mm and the T antenna for the Frsky R9M.
Use a small piece of 3m foam tape to keep the receiver in place. Also make sure that there are no sharp bends in your antenna wire to keep signal integrity. I have gotten some impressive distances with this setup.
Print at whatever settings you want. I printed at .2mm with 20% infill.
My designs are powered by beer, time, and filament. If you like my design and feel gener
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in