Sidewinder 115 mm Long for RC Models with 80 to 100 CM Wingspan.

Hi, I was looking for some Sidewinder rockets for my 60 cm span Grippen built from the plan on RC Groups but they were all a bit big and as I have had problems 'shrinking' stuff before I knocked these out. I tried to print joiner sections into the nose and tail but it failed so I just added small joiner tubes but simple paper tubes smeared with glue would also work.

The model is solid so use low infill or do what I did and use Vase or Corkscrew mode to print with 1 outer layer. I used 0.1 mm