Thingiverse
2mm and 1mm higher BLTouch Mount & Fan Spacer for Anet A6 Titan Aero Carriage
by GuusR
10
Downloads
6
Likes
0
Makes
This is a remix of RJFeddeler's BLTouch mount for the Anet A6 Titan Aero carriage.
After printing I found that the BLTouch probe was a little bit too low (same height as nozzle when retracted). To prevent the BLTouch from catching on a print I've added 2 mm height to the mount.
I'm using the Trianglelab 3D-touch off aliexpress. I'm not sure if this has the same dimensions as the official BLTouch or other clone's so your dimensions may be different.
==EDIT==
I found the +2mm is a little
After printing I found that the BLTouch probe was a little bit too low (same height as nozzle when retracted). To prevent the BLTouch from catching on a print I've added 2 mm height to the mount.
I'm using the Trianglelab 3D-touch off aliexpress. I'm not sure if this has the same dimensions as the official BLTouch or other clone's so your dimensions may be different.
==EDIT==
I found the +2mm is a little
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in