Thingiverse
Inokim GoPro Hero Mount
by Rederic
11
Downloads
14
Likes
0
Makes
Mount for a GoPro Hero 4 on an Inokim Scooter. I designed it for the Ox, but it may fit other larger models depending on their stem width.
This attaches to the adhesive mount that came with the camera. Refer to pictures for installation. I designed it for 3x 7.6mm wide zip straps to be threaded through, and used a sheet of rubber between it and the stem to keep it from sliding.
Printable with no supports, with the flat part down.
This attaches to the adhesive mount that came with the camera. Refer to pictures for installation. I designed it for 3x 7.6mm wide zip straps to be threaded through, and used a sheet of rubber between it and the stem to keep it from sliding.
Printable with no supports, with the flat part down.
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in