Thingiverse
Pi TFT plus Console Case for 3.5 Inch Displays - remix for displays withou mounting holes
by eremit
8
Downloads
5
Likes
0
Makes
Pi TFT plus Console Case for 3.5 Inch Displays
Some additions for using displays without mounting holes: The support frame to place between Display und PI to give the display a better foundation then the connector plug alone could give (fits tightly when done on the same printer). The Top cover is a little thicker (1.5 mm) and more closed to hide the edges of the Display. Especially made for the Geekcreit Display (but fitting all types with a the bigger dead area on the right side of the Disp
Some additions for using displays without mounting holes: The support frame to place between Display und PI to give the display a better foundation then the connector plug alone could give (fits tightly when done on the same printer). The Top cover is a little thicker (1.5 mm) and more closed to hide the edges of the Display. Especially made for the Geekcreit Display (but fitting all types with a the bigger dead area on the right side of the Disp
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in