Thingiverse
Mouse Bungee
by Pixelcloud
85
Downloads
83
Likes
1
Makes
Hello !
This is Mouse Bungee for better cable management. Cable mount should work for 2.5-4mm cable thickness. To add some weight, drill holes at the bottom and apply some plaster/concrete. Add rubber/silicone feets to prevent sliding on the table. Print without supports.
You need Springs with this parametes:
Length: 60mm
Out diameter: 3mm
Inner diameter: 1.9mm
Wire diameter: 0.5mm
You can order them on chinese website with 0.70$ per 5.(I don't get anything by posting link to shop):
This is Mouse Bungee for better cable management. Cable mount should work for 2.5-4mm cable thickness. To add some weight, drill holes at the bottom and apply some plaster/concrete. Add rubber/silicone feets to prevent sliding on the table. Print without supports.
You need Springs with this parametes:
Length: 60mm
Out diameter: 3mm
Inner diameter: 1.9mm
Wire diameter: 0.5mm
You can order them on chinese website with 0.70$ per 5.(I don't get anything by posting link to shop):
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in