Thingiverse
Ceiling support, to mount a LED panel of 220x220 mm.
by J_RPM
1
Downloads
5
Likes
0
Makes
Construction of a support with PETG, to hold on the ceiling a LED panel of 220x220 mm.
The LED panel support is attached to the ceiling with 4 screws, one in each corner. The constant current supply device and the wiring have also been fastened to the ceiling with screws. The fixing system of the LED panel with the housing is made up of 8 neodymium magnets, 4 of them stuck on the LED panel and the other four fixed on the outside of the support with double-sided adhesive tape.
Once the magnets
The LED panel support is attached to the ceiling with 4 screws, one in each corner. The constant current supply device and the wiring have also been fastened to the ceiling with screws. The fixing system of the LED panel with the housing is made up of 8 neodymium magnets, 4 of them stuck on the LED panel and the other four fixed on the outside of the support with double-sided adhesive tape.
Once the magnets
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in