Thingiverse
Enclosure for HW-DY02 DC transformer module
3
Downloads
3
Likes
0
Makes
Simple case for a HW-DY02 12v to 5v / 3v3 transformer module
It's not designed to be completely enclosed, rather there is a gap in the lid for access to the output pins.
Design is in three parts: a base for the board to slot into, a lid on top, and a cap for the power switch to fit through the hole allowing you to turn it on and off without removing the lid.
My first venture into 3D design and Sketchup, so any comments/improvements will be welcomed!
It's not designed to be completely enclosed, rather there is a gap in the lid for access to the output pins.
Design is in three parts: a base for the board to slot into, a lid on top, and a cap for the power switch to fit through the hole allowing you to turn it on and off without removing the lid.
My first venture into 3D design and Sketchup, so any comments/improvements will be welcomed!
Makes
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign in